Wolverine Airsoft

Replacement 8.5″ wire harness to connect the MTW Forged Trigger Board Assembly to the Premium GEN 2 FCU...

This is a V3 Trigger Board for use with the Wolverine Airsoft SMP, Reaper, or  Inferno Gen 1 or GEN 2 engine...

This is a V2 Trigger Board for use with the Wolverine Airsoft SMP, Reaper, or  Inferno Gen 1 or GEN 2 engine...

Includes: Jumper Board Micro Switch Wire Extensions (x2) 0.63” x 1” Shrink Tube 1.25” x 1/4” Clear Heat Shrink 1/16” Drill bit 20×6 TX Panhead Self-Tapping Screw..

  Recommended for 509mm (inner barrel length) or longer...

The BOLT High Pressure Kit is designed to increase your air efficiency with the BOLT when running at higher pressure. It is not intended to increase fps or range, but to save air. *Only compatible with the standard Bolt, not the Bolt M. Includes: Red High Pressure SpringTuning Shim x3..

Replacement Selector Switch for the MTW...

Replacement Spanner Wrench for your Wolverine Airsoft STORM InGRIP...

This is for WRAITH CO2 Stocks and WRAITH: CO2 Adapters. Includes hook wrench for servicing seat and o-ring seals...

..

The STORM Category 5 is the next evolution of the STORM regulator, the original dedicated airsoft regulator. The Category 5 is optimized for reliably fast, adaptable, and consistent performance across the entire pressure range needed for HPA products. Get the most out of your Wolverine Airsoft HPA s..

The second piece of the STORM Regulator saga is a version that can be mounted in the grip of standard M4 guns. Moving the regulator closer to the gun results in an even faster recharge rate and the ability to effectively use CO2! CO2 is a less-expensive alternative to HPA and provides approx..