- Stock: In Stock
- Model: 19014
Technical specifications
Nominal voltage: 11.1 V (3S – three cells in series)
Capacity: 900 mAh
Discharge rate: 15 C (≈ 13.5 A DC)
Package type: Stick Mini-Type (compact, designed for airsoft replicas with limited space)
Connector: Mini-Tamiya
Estimated dimensions: ~95mm length x 20mm width x 17mm height
Typical use: powering small AEG replicas or PDWs
Associated hazards and risks
Deep discharge
If the voltage drops below ~3.0 V/cell, the battery is irreversibly damaged.
It may become unusable or dangerous when recharged.
Overcharge
Above 4.2 V/cell there is a risk of swelling, toxic gas leakage, fire or explosion.
Charging should only be done with a Li-Po charger with a balancing function.
Too high current (above the C limit)
If the replica requires more current than the battery can deliver, it will overheat.
Internal short circuit and fire may occur.
Mechanical punctures or impacts
Physical damage to the cells can lead to violent chemical reactions → instant flame.
Inappropriate temperature
>60 °C: rapid degradation, risk of explosion.
<0 °C: low performance, risk when charging.
Unattended charging
There have been cases of fires during charging.
Charging should be done under supervision and in a fireproof bag (Li-Po bag).
Storage
Do not leave the battery completely discharged; the voltage must be within the recommended range (~3.8 V/cell for storage).
Do not leave the battery connected to the replica when not in use. Even when the replica is turned off, "parasitic" consumption can discharge the battery below the safe limit.
Store the battery in a cool place, away from fire and, ideally, in a fireproof bag.
Damaged, swollen or deformed batteries should not be used.
Safety recommendations
Use only dedicated Li-Po chargers with balancing.
Check and maintain the appropriate charge level for storage.
Do not expose the battery to water, shock or short circuits.
| Technical | |
| Amperage | 900 |
| Voltage | 11.1 |
